What about an aggressive corrosive environment for the cutters that are typically above the waterline? The Monster Stack uses corrosion-resistant stainless steel cutters from your typical waterline to the top of the cutter stack. Why wouldn’t you use stainless steel in the whole cutter stack? Stainless steel is a softer metal than the alloy steel of a typical grinder cutter. Therefore, stainless steel cutters will wear faster in an abrasive grinding application. No longer do you have to choose between abrasion-resistant cutters or corrosion-resistant cutters. The Monster Stack uses stainless steel cutters where corrosion resistance is needed and alloy steel cutters where abrasion resistance is needed. The right cutter at the right location.
- Have a problem with wipes? Use a Wipes Ready cutter specifically designed to shred wipes into pieces that will not cause problems for downstream pumps.
- Need a very small particle size? Use a thin, high-tooth count cutter to shred solids into small particles.
- Have a variety of solids and want an all-purpose cutter? Use a general-purpose cutter. .
The right cutter at the right location.
The possible configurations are unlimited. The Monster Stack is designed specifically for your application to give you the right cutters to address your specific grinding challenges in your waste stream, optimizing grinder performance and longevity